SOLD
Fadal VMC-4020HT CNC Vertical Machining Center
Fadal VMC4020HT/
Ref: 1004
Serial No. 01200496839/ Age: 2005/
Condition: Excellent/
| Specification | Description |
|---|---|
| Table | 47.94" x 20" |
| Max Table Load | 1000 lbs |
| Spindle nose to table top | 4-24" |
| X-axis Travel | 40 |
| Y-Axis Travel | 20" |
| Z-Axis Travel | 20 |
| Rapid Travel | 400 ipm |
| Spindle Taper | CAT-40 |
| Spindle Speeds | 0- 10000 RPM |
| Spindle motor | 20HP |
| Tool Changer Capacity | 21 stations |
| Max tool weight | 15 lbs |
| Machine weight | 10500 |
| Machine dimensions | 116" x 87" x 104"H |
These machines are being rebuilt by the original members of the Fadal® Reman Division and are held to the same high standards as a new machine. . Fadal® Remanufacture Process 1. Remove sheet metal, sandblast, and powder coat 2. Remove saddle and table Re-apply Turcite® saddle and table Install new Waylube® system Install new copper Waylube® line Install new table straps Install new saddle straps Install new adjustable gibs 3. Remove Head Re-apply Turcite® to Head Install new Waylube® system Install new copper Waylube® line Install new head straps 4. Inspect 'ways' and reground if needed 5. Remove tool changer and replace all bad parts 6. Clean electrical box and power box Inspect power cables and replace if necessary Inspect logic cables and replace if necessary Control upgrade -5 system Install new axis motors for X,Y, and Z Install new axis AMPS for X,Y, and Z Rebuild spindle motor or install new motor Rebuild inverter or install new inverter Inspect all contacts and power board 7. Inspect spindle and mechanical system Rebuild spindle Install new motor mounts New 'pozi' belts Rebuilt idler assembly and Drabar® system 8. Inspect ball screw assembly Rebuild ballscrew or install new if needed New X,Y, & Z bearings 9. Inspect way covers Repair and/or install new rubber wipers X,Y, and Z or install new way covers 10. Flycut and scrape table 11. Inspect laser and ballbar 12. Install rebuilt sheetmetal and new Lexan® windows & Fadal® stickers 13. Initiate 24-hour break- in cycle
Equipped With:
On-Time Hours: 9096 Run Time Hours: 2492 10K RPM Spindle Rigid Tap High-Speed CPU Flat Panel Display 4th axis pre-wire RS232 Port
